Pack201 | Operator Interface | Section 4
EN | 53
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Message Action
INCREASING FILM�
ADJUST FILM TO GET INTO REGISTRATION
DECREASING FILM
ESTOP BUTTON PRESSED� PULL OUT THE ESTOP BUTTON TO ENABLE WRAPPER START BUT-
TON�
SAFETY RELAY OUTPUT� CLOSE GUARD DOORS AND PULL OUT ESTOP PB’S TO ENABLE
WRAPPER START�
HIGH PRODUCT STOP� THE HIGH PRODUCT DETECTION CIRCUIT WAS TRIGGERED�
PRESS START TO RUN�
AUTO WAITING� MACHINE WAITING FOR SIGNAL TO RUN� CAUTION! THE MA-
CHINE MAY START AT ANY TIME!
STANDBY� WAITING FOR DOWNSTREAM
EQUIPMENT�
CHECK DOWNSTREAM EQUIPMENT FOR THE REASON WHY THE
WRAPPER STOPPED� USE CAUTION! THE WRAPPER MAY START
AT ANY TIME�
LOW AIR STOP� AIR PRESSURE SENSOR DETECTED LOW AIR� CHECK AIR
INPUT
MACHINE CAN NOT RUN IF NOT IN SYNC� RETURN TO MANUAL OR AUTO MODE AND PRESS START BUTTON
TO SYNC THE MACHINE�
FILM BROKEN STOP� CHECK THE FILM PATH OR THE PROXIMITY SENSOR� PRESS
START TO RUN�
RESET SPLICER� PRESS THE RESET SPLICER BUTTON ON KEY PAD TO RE-ARM THE
SPLICER�
INFEED INCREASING� THE INFEED IS INCREASING TO THE NEW OFFSET�
INFEED DECREASING� THE INFEED IS DECREASING TO THE NEW OFFSET�
TEMPERATURE FAULT STOP� LOOK AT TEMPERATURE CONTROLLER OR ITS MANUAL
FOR MORE INFORMATION�
DISCHARGE FOLLOWING ERROR� CHECK THE FEEDBACK IN E-STOP TO RESET THE FOLLOWING ER-
ROR OR PRESS START BUTTON TO RUN�
LOW FILM ERROR� FILM MONITORING CIRCUIT DETECTED LOW FILM�
UNCUT REJECT� NO GAP DETECTED BETWEEN PACKAGES ON THE DISCHARGE
PACKAGES INVOLVED WERE REJECTED�
SPLICE REJECT� A SPLICE WAS PERFORMED AND THE PACKAGES INVOLVED
WERE REJECTED�
MANUFACTURERS SPLICE REJECT� A MANUFACTURERS SPLICE WAS DETECTED AND REJECTED�
OUT OF REGISTRATION REJECT� PACKAGE FOUND TO BE OUTSIDE THE PRESET LIMITS OF REGIS-
TRATION ERROR
MELTED FILM REJECT� PRODUCT HELD OVER FINWHEELS LONGER THAN PRESET TIME
AND WAS REJECTED�
NO GAP / NO SEAL REJECT� PRODUCT WAS DETECTED WITHIN THE PRESET WINDOW
AND REJECTED�
To Next Page
Loading...