42 en | Installation Plena Voice Alarm System
9922 141 1037x (V2.16) | V0.6 | 2011.09 Installation and Operation manual Bosch Security Systems B.V.
Figure 4.5 Trigger input indication
5. In the configuration program, set the Action Programming for the relevant input to Fault
and EOL.
6. Enter the Zone or Zone group that is monitored by the EOL board. The Zone group can be
All Zones (of the Controller/Router), Zone 1-3 or Zone 4-6. Fault Type and Zone will
define the visual indication on the unit in case of a fault.
7. Set the Action to Open and Type to Momentary. See Figure 4.6 for an example.
Figure 4.6 Action programming window in configuration program.
JP1 JP1 JP1
Last EOL board
First EOL board
20k
To Next Page
Loading...
