English | 19
Digital laser measure GLM 500
Sound setting ●
A) For measurements from the front edge of the meas-
uring tool, this applies for high reflectivity of the tar-
get (e.g. a white-painted wall), weak backlighting
and 25°C operating temperature. In addition, a devi-
ation of ±0.05mm/m must be taken into account.
B) For measurements from the rear edge of the measur-
ing tool, applies to low reflectivity of the target (e.g.
a dark-painted wall), strong backlighting and –10 °C
to +45 °C operating temperature. In addition, a devi-
ation of ±0.15 mm/m must be taken into account.
C) After user calibration at 0° and 90°; an additional
pitch error of ±0.01° up to 45° (max.) must be taken
into account. The left-hand side of the measuring
tool serves as the reference level for inclination
measurement.
D) At an operating temperature of 25 °C
E) The left-hand side of the measuring tool serves as
the reference level for grade measurement.
F) In continuous measurement mode, the max. operat-
ing temperature is +40 °C.
G) Only non-conductive deposits occur, whereby occa-
sional temporary conductivity caused by condensa-
tion is expected.
H) Except battery compartment
The serial number (11) on the type plate is used to clearly
identify your measuring tool.
Bosch Power Tools 1 609 92A 5E4 | (07.05.2020)
To Next Page
Loading...
