English | 27
above it.
Volume measurement
Select the volume measurement mode
.
Then measure the width, length and depth one
after the other as with a length measurement. The
laser beam remains switched on between the three
measurements. The distance to be measured
flashes in the indicator for volume measurement
.
1474.8 m
12.700 m
3
11.430
0.0°
m
m10.160
The first measured value is shown at
the top of the display.
After the third measurement has been
completed, the volume will be auto-
matically calculated and displayed. The
end result is shown at the bottom of the display,
while the individual measured values are shown
above it.
Indirect distance measurement
For indirect length measurements, three measur-
ing modes are available. Each measuring function
can be used for determining different distances.
The indirect distance measurement is used to de-
termine distances that cannot be measured dir-
ectly, due to an obstacle that would impede the
Bosch Power Tools 1 609 92A 5E4 | (07.05.2020)
To Next Page
Loading...
