Bosch Professional GLM 500 - Deleting the memory; Adding;subtracting values

32 | English
If there is no value available in the memory, 0.000
is shown at the bottom of the display and 0 at the
top.
The oldest value is located in position 1 in the
memory, while the newest value is in position 20
(when 20 memory values are available). When a
further value is saved, it is always the oldest value
in the memory that is deleted.
Deleting the memory
Press the memory button (6) [
] to delete the
contents of the memory. Then briefly press the on/
off button (5) [
] to delete the displayed meas-
ured value.
To delete all values in the memory, press the but-
ton (4) and the on/off button (5) [
] at the same
time, then release the on/off button (5) [
].
Adding/subtracting values
Measured values or end results can be added or
subtracted.
Adding values
The following example describes the addition of
areas:
Measure an area as described in the section on
area measurement (see "Area measurement",
page26).
1 609 92A 5E4 | (07.05.2020) Bosch Power Tools