Bosch Radion B810 - Programming wireless points in the control panel

26 en | RADION receiver SD RADION receiver SD
2020.05 | 13 | F.01U.261.834 Bosch Security Systems B.V.
R
Y
G
B
2
1
SDI Connector
SDI2 Connector
36
35
34
33
32
31
SDI
RED
POWER +
YELLOW
DATA BUS A
GREEN
DATA BUS B
s before servicing.
SDI2
RED
POWER +
YELLOW
DATA BUS A
GREEN
DATA BUS B
BLACK
COMMON
4
3
Figure3.2: Wiring the receiver to an SDI2 compatible control panel
Callout ￚ Description
1 ￚ SDI2 compatible control panel
2 ￚ Terminal wiring
3 ￚ RADION receiver SD mounting base
4 ￚ Module terminal block
3.4.4 Programming wireless points in the control panel
Configure the RADION points to establish communication
between the RADION system and the control panel. This can be
accomplished by using one of two methods:
– Using Remote Programming Software (RPS) on a supported
laptop computer, or
– Compatible keypad devices to enable your points
A “point” can be a detection device, or a group of devices
connected to your security system.