RADION receiver SD General installation | en 9
Bosch Security Systems B.V. 2020.05 | 13 | F.01U.261.834
2.1 Installation workflow
To install, configure, and test the system, use the workflow
below and follow in sequential order, from top to bottom,
checking each box as you complete a step.
Notice!
Always power down the control panel when connecting
modules, or other wiring. Power down the control panel by
unplugging the transformer and disconnecting the battery
Plan the installation of the RADION system
Install the RADION components (refer to the graphical
installation guides and this system reference guide for details)
Program wireless points in the control panel
Enroll point RF ID for wireless points
Verify LED responses on devices
Perform a local walk test for installed detectors
Review signal strength and margin of each point
Complete the installation
2.2 Unpacking information
When unpacking the receiver, repeater, or bill trap device, it is
important to remove the cardboard insert as illustrated below;
To Next Page
