Bosch Rexroth 10 Series - Page 18

Bosch Rexroth AG, RE 92650/2020-03-03
18 A1VO Series 10 | Axial piston variable pump
Dimensions size 35
Dimensions [mm]
▼ D3/D4 Pressure controller with override,
electric-proportional, clockwise rotation
▼ D3/D4 Pressure controller with override,
electric-proportional, counter-clockwise rotation
143.5
135
135
X
143.5
▼ Splined shaft SAE J744 ▼ Splined shaft SAE J744
S4 – 7/8 in 13T 16/32DP
1)
S5 – 1 in 15T 16/32DP
1)
41
33
18
Ø 56.9
46
38
23
Ø 56.9
Ports and fastening threads version "B"
Ports Standard
2)
Size p
max abs
[bar]
3)
State
6)
B Working port ISO 11926 1 5/16-12UN-2B; 20 deep 280 O
S Suction port ISO 11926 1 5/8-12UN-2B; 20 deep 5 O
L
1
Drain port ISO 11926 3/4-16UNF-2B; 15 deep 10 O
4)
L
2
Drain port ISO 11926 3/4-16UNF-2B; 15 deep 10 X
4)
X Pilot signal ISO 11926 7/16-20UNF-2B; 12 deep 280 O
5)
Ports and fastening threads version "M"
Ports Standard
2)
Size p
max abs
[bar]
3)
State
6)
B Working port ISO 6149 M33 × 2; 20 deep 280 O
S Suction port ISO 6149 M42×2; 20deep 5 O
L
1
Drain port ISO 6149 M18 × 1.5; 13 deep 10 O
4)
L
2
Drain port ISO 6149 M18 × 1.5; 13 deep 10 X
4)
X Pilot signal ISO 6149 M12 × 1.5; 12 deep 280 O
5)
Notice
At all ports - in particular when connecting port S - use
the stud ends provided for the standard with the
corresponding width across flats. Please contact us about
larger widths across flats.
1) Involute spline according toANSI B92.1a, 30° pressure angle,
flatroot, side fit, tolerance class 5
2) The countersink may bedeeper than specified inthe standard.
3) Depending onthe application, momentary pressure peaks can
occur. Keep this inmind when selecting measuring devices and
fittings.
4) Depending on the installation position, L
1
or L
2
must be connected
(see also the installation instructions onpage23).
5) Only if an S0 controller is present.
6) O = Must beconnected (comes plugged)
X = Plugged (in normal operation)