Bosch Rexroth 10 Series - Dimensions for through Drives

RE 92650/2020-03-03, Bosch Rexroth AG
19 Axial piston variable pump | A1VO Series 10
Dimensions for through drives
Dimensions [mm]
Dimensions for through drives
Flange SAE J744 Hub forsplined shaft
1)
Availability NG Code
Diameter Mounting
2)
Designation Diameter Designation 18 28 35
82-2 (A)
A2 5/8 in 9T 16/32 DP S2 ● ●
●
A2S2
3/4 in 11T 16/32 DP S3 ● ●
●
A2S3
7/8 in 13T 16/32 DP S4 ● ●
●
A2S4
101-2 (B)
B2 7/8 in 13T 16/32 DP S4 ● ●
●
B2S4
1 in 15T 16/32 DP S5 – –
●
B2S5
●
= Available
○
= On request
–
= Not available
1) Inaccordance with ANSI B92.1a, 30° pressure angle, flat root,
sidefit, Tolerance Class 5
2) Mounting holes pattern viewed onthrough drive with working
portB on right.
3) Continuous thread according toDIN 13, see instruction manual for
details on tightening torques.
4) Wave length for pumps with mounting flanges according
toISO3019-1
▼ 82-2 (A)
M2
106.4
M10 x 1.5
3)
8
Ø82.55
+0.02
+0.05
M1 (to mounting flange)
Code NG M1 M2
minimum
4)
A2S2 18 203.2 31
28 203.2 31
35 227.6 31
A2S3 18 203.2 37
28 203.2 37
35 227.6 37
A2S4 18 203.2 40
28 203.2 40
35 227.6 40
▼ 101-2 (B)
M2
146
M12 x 1.75
3)
11
Ø101.6
+0.02
+0.05
M1 (to mounting flange)
Code NG M1 M2
minimum
4)
B2S4 18 203.2 40
28 203.2 40
35 227.6 40
B2S5 35 227.6 45