Bosch Rexroth 10 Series - Safety Instructions; General Safety Instructions; Product-Specific Safety Instructions; About This Product

RE 92650/2020-03-03, Bosch Rexroth AG
3 Axial piston variable pump | A1VO Series 10
Type code
2) For size 35, not for through drive
3) Inaccordance with ANSI B92.1a
4) Mounting holes pattern viewed onthrough drive with working
portB on right.
01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18
A1V O 2 0 / 10 V 00 – 0
Drive shaft (permissible input torque, see page8) 18 28 35
14 Splined shaft ANSI B92.1a
(Bosch Rexroth recommends selecting the
respectively larger drive shaft for through drive units)
3/4 in 11T 16/32DP
● ● – S3
7/8 in 13T 16/32 DP
2)
● ● ● S4
1 in 15T 16/32DP
– – ● S5
Parallel keyed shaft
Through drive not permissible
ISO 3019-1 SAE Ø 19-1
● ● – K3
ISO 3019-2 metric Ø 20
● ● – P3
Working port 18 28 35
15 Threaded ports B and S, lateral, on opposite sides
● ● ● 1
Threaded ports B and S, rear, not for through drive
● ● ○ 9
Through drives (for mounting options, see page20)
16 Flange SAE J744 Hub forsplined shaft
3)
Diameter Mounting
4)
Designation Diameter Designation
18 28 35
Without through drive ● ●
● 0000
82-2 (A)
A2 5/8 in 9T 16/32 DP S2 ● ●
● A2S2
3/4 in 11T 16/32 DP S3 ● ●
● A2S3
7/8 in 13T 16/32 DP S4 ● ●
● A2S4
101-2 (B)
B2 7/8 in 13T 16/32 DP S4 ● ●
● B2S4
1 in 15T 16/32 DP S5 – –
● B2S5
Reduction ofgeometric displacement
17 Without reduction
00
Standard/special version
18 Standard version
0
●
= Available
○
= On request
–
= Not available
Notes
Note the project planning notes onpage25.