Bosch Rexroth 10 Series - Product-Specific Safety Instructions

RE 91485-01-B/2021-11-18, BoschRexrothAG
Safety instructions | A10FZO/G, A10VZO/G 11/72
2�6 Product-specific safety instructions
The following safety instructions apply to chapters 6 to 14.
WARNING
Danger due to excessive pressure!
Risk of death or injury, or property damage!
Improperly changing the factory pressure settings can result in apressure
increase beyond the permissible maximum pressure.
Operating the unit above the maximum permissible pressure can cause
components to burst and hydraulic fluid to escape under high pressure.
▶ Changes to the factory settings may only be made by BoschRexroth
specialists.
▶ In addition, apressure relief valve is required in the hydraulic system as
back-up. If the axial piston unit is equipped with apressure cut-off and/or
pressure controller, this is not an adequate safeguard against pressure overload.
Danger due to suspended loads!
Risk of death or injury, or property damage!
Improper transportation may cause the axial piston unit to fall down and lead to
injury, e.g.crushing or fracture, or damage to the product.
▶ Make sure that the load bearing capacity of the lifting device is sufficient to
safely bear the weight of the axial piston unit.
▶ Never step or grip under suspended loads.
▶ Ensure astabletransport position.
▶ Use your personal protective equipment (e.g.safety goggles, safety gloves,
suitableworking clothes, safety shoes).
▶ Use suitablelifting devices for transport.
▶ Observe the prescribed position of the lifting strap.
▶ Observe the national laws and regulations on occupational health and safety,
and transportation.