Bosch Rexroth 10 Series - Page 30

BoschRexrothAG, RE 91485-01-B/2021-11-18
30/72 A10FZO, A10VZO, A10FZG and A10VZG series 10 | Transport and storage
The following instructions only refer to axial piston units operated with
hydraulic fluid on amineral oil basis. Other hydraulic fluids require other
specific preservation measures. In such acase, consult your local contact
person; you can find their contact information at
https://addresses.boschrexroth.com
BoschRexroth recommends the following procedure:
1� Clean the axial piston unit; see chapter 10.1 "Cleaning and care" on page 58.
2� Drain the axial piston unit.
3� For storage times up to 12 months: Moisten the inside of the axial piston unit
with mineral oil and fill with approx. 100 ml mineral oil.
For storage times up to 24 months: Fill the axial piston unit with VCI 329
corrosion protection (20 ml).
Filling is carried out via drain port L, L
1
or L
2
, see chapters7.5
"Installing the axial piston unit", Abb. 27 to Abb. 30 starting on page48.
4� Plug all ports so they are airtight.
5� Coat unpainted areas of the axial piston unit with mineral oil or suitable,
easily removable corrosion protection, e.g.acid-free grease.
6� Pack the axial piston unit with desiccant in an airproof manner in corrosion
protection film.
7� Store the axial piston unit in ashock-proof manner; see "Requirement"
on page 28 in this chapter.