Bosch Rexroth A15VSO - 2.6 Product-specific safety instructions

Safety instructions 11/60
RE 92801-01-B/11.2018, A15VSO/A15VLO Series 11, BoschRexrothAG
2.6 Product-specific safety instructions
The following safety instructions apply tochapters 6 to14.
WARNING
Danger from excessive pressure!
Danger tolife, risk ofinjury orproperty damage!
Improperly changing the factory pressure settings can result inapressure increase
beyond the max. permissible pressure.
Operating the unit above the max. permissible pressure can cause components
toburst and hydraulic fluid toescape under high pressure.
▶ Changes tothe factory settings may only bemade byBoschRexroth specialists.
▶ In addition, apressure relief valve isrequired inthe hydraulic system
asaback-up. If the axial piston unit isequipped with apressure cut-off and/or
pressure controller, this isnot anadequate safeguard against pressure overload.
Danger due tosuspended loads!
Danger tolife, risk ofinjury orproperty damage!
Improper transportation may cause the axial piston unit tofall down and lead
toinjury, e.g.crushing orfracture, ordamage tothe product.
▶ Make sure that the load bearing capacity ofthelifting device issufficient
tosafely bear the weight oftheaxial piston unit.
▶ Never step orgrip under suspended loads.
▶ Ensure astable transport position.
▶ Use your personal protective equipment (e.g.safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ Use suitable lifting devices for transport.
▶ Observe the prescribed position ofthelifting strap.
▶ Observe the national laws and specifications ofoccupational safety and health
and transport.
System/machine under pressure!
Risk ofdeath orserious injury when working onunsecured machines/systems!
Property damage!
▶ Switch off the entire system and secure itagainst reactivation according tothe
parameters provided bythemachine/system manufacturer.
▶ Ensure that all relevant components ofthehydraulic system are depressurized.
For this purpose, observe the parameters indicated bythemachine/system
manufacturer.
▶ Please note that the hydraulic system might still bepressurized event after
separation from the actual pressure supply.
▶ Do not disconnect any line connections, ports orcomponents aslong
asthehydraulic system isunder pressure.