Bosch Rexroth A15VSO User Manual

34/60 Installation
Bosch Rexroth AG, A15VSO/A15VLO Series 11, RE 92801-01-B/11.2018
7.4.6 Installation with cardan shaft
The following describes how toconnect the axial piston unit tothe drive motor with
acardan shaft.
NOTICE! Damage tothe axial piston unit and leaks attheshaft seal!
Improperly installed cardan shafts generate unbalances. This results invibrations
and excessive forces onthe drive shaft.
▶ Observe the cardan shaft manufacturer's assembly instructions.
1. Place the axial piston unit near the intended installation location. Allow enough
space for the cardan shaft tofit through onboth sides.
2. Place the cardan shaft onthe output shaft ofthedrive motor.
3. Push the axial piston unit tothe cardan shaft and place the cardan shaft onthe
drive shaft oftheaxial piston unit.
4. Bring the axial piston unit tothe installation position and fasten it. Details
oftherequired tools and tightening torque for the mounting bolts can
beobtained from the system manufacturer.
7.4.7 Completion of assembly
1. Remove any installed transport screws.
CAUTION! Operation with protective plugs!
Operating the axial piston unit with protective plugs may result ininjury ordamage
tothe axial piston unit.
▶ Before commissioning, remove all protective plugs and replace them with
suitable, pressure-resistant, metal threaded plugs orconnect the appropriate
lines.
2. Remove the transport protection.
The axial piston unit comes with protective covers(1) and threaded plugs(2).
They are not pressure-resistant and have toberemoved prior toconnection. Use
asuitable tool for this toprevent damage tothe sealing and functional surfaces.
Ifsealing orfunctional surfaces are damaged, contact your BoschRexroth service
partner ortheservice department ofthefactory that manufactured the axial
piston unit.

Bosch Rexroth A15VSO Specifications

General

Brand	Bosch
Model	Rexroth A15VSO
Category	Water Pump
Language	English