Bosch Rexroth A15VSO - 8 Commissioning; 8.1 Initial commissioning

Commissioning 43/60
RE 92801-01-B/11.2018, A15VSO/A15VLO Series 11, BoschRexrothAG
8 Commissioning
WARNING
Danger while working inthe danger zone ofamachine/system!
Danger tolife, risk ofinjury orserious injury!
▶ Pay attention toand eliminate potential danger sources before commissioning
the axial piston unit.
▶ Make sure noone isinthe danger zone ofthemachine/system.
▶ The emergency stop button for the machine/system should bewithin the
operator's reach.
▶ Always follow the instructions ofthemachine/system manufacturer during
commissioning.
CAUTION
Commissioning animproperly installed product!
Risk ofinjury and property damage!
▶ Make sure all electrical and hydraulic ports are connected orplugged.
▶ Commission only afully installed, fully functioning product with original
accessories from BoschRexroth.
8.1 Initial commissioning
During all commissioning work onthe axial piston unit, observe the general safety
instructions and intended use detailed inchapter2 "Safety instructions"
onpage8.
▶ Connect the pressure gage for the working pressure, case pressure and suction
pressure tothe specified measuring points onthe axial piston unit orinthe
hydraulic system, tocheck the technical data atfirst operation.
▶ During commissioning, monitor the temperature ofthehydraulic fluid inthe
reservoir toensure that itlies within permissible viscosity limits.
8.1.1 Filling the axial piston unit
Professional filling and air bleeding isnecessary toprevent damage tothe axial
piston unit and tomaintain proper function.
Usually, the cleanliness level ofcommercial hydraulic fluids isinsufficient for our
components. These hydraulic fluids must befiltered using anappropriate filter
system tominimize solid particle contamination and water inthe system.