Bosch Rexroth A15VSO User Manual

Installation 33/60
RE 92801-01-B/11.2018, A15VSO/A15VLO Series 11, BoschRexrothAG
4. Remove dirt and foreign particles from the installation location.
5. Install the coupling onthe output shaft ofthedrive motor inaccordance with the
specifications provided bythecoupling manufacturer.
Do not fasten down the axial piston unit until the coupling has been correctly
installed.
6. Fasten the axial piston unit attheinstallation location.
7. Align the drive shaft oftheaxial piston unit and the output shaft ofthedrive
motor sothere isno angular deviation.
8. Make sure noexcessive axial and radial forces are acting onthe drive shaft.
9. For bell housing installation, check the coupling axial play through the bell
window according tothe manufacturer's specifications.
10. Details onthe required tools and tightening torques for the mounting bolts are
available from the machine/system manufacturer.
11. When using elastic couplings, check that the drive does not resonate after
completing the installation.
7.4.5 Installation on a gearbox
The following describes how toinstall the axial piston unit ona gearbox.
After installing ona gearbox, the axial piston unit iscovered and isdifficult toaccess:
▶ Before installing, make sure that the spigot diameter centers the axial piston unit
(observe tolerances) and that noexcessive axial orradial forces are acting onthe
drive shaft oftheaxial piston unit (installation length).
▶ Protect the drive shaft against frictional corrosion byproviding permanent
lubrication.
▶ Fasten the axial piston unit attheinstallation location.
Nogearing forces higher than the permissible axial and radial forces should act
onthe shaft; ifnecessary, support the gear wheel atthegearbox output separately.
For attachment via gear
wheel orhelical gear shaft

Bosch Rexroth A15VSO Specifications

General

Brand	Bosch
Model	Rexroth A15VSO
Category	Water Pump
Language	English