Bosch Rexroth A15VSO User Manual

Installation 37/60
RE 92801-01-B/11.2018, A15VSO/A15VLO Series 11, BoschRexrothAG
• Drain line
– Always route the drain lines sothat the housing isconstantly filled with hydraulic
fluid and toensure noair gets through the shaft seal, even during extended
standstill periods.
– The case pressure must never exceed the limit values specified for the axial
piston unit inthe data sheet.
– The drain line inflow inthe reservoir should always bebelow the minimum fluid
level (seechapter7.3 "Installation position" onpage 28).
• If the axial piston unit isequipped with installed screw fittings, do not remove
them. Screw the stud end ofthefitting directly into the installed fitting.
Axial piston units are used inapplication areas that use the metric system aswell
astheAnglo-American (imperial) and the Japanese measuring system (JIS – Japan
Industrial Standard). Various kinds ofseals are also used.
The system ofunits, the kind ofseal and the size offemale thread and stud ends
(e.g.threaded plug) must all match.
There isarisk ofconfusion due tothe limited ways ofvisually telling them apart.
WARNING! Leaky orbursting stud ends!
For fittings, ifastud end that does not match the system ofunits, kind ofseal and
size ofthefemale thread ispressurized, the stud end may loosen itself oreven
beejected from the hole inaprojectile-like manner. This can result inserious injury
and property damage. Hydraulic fluid can escape from this leakage point.
▶ Use the drawings (installation drawing) todetermine the required stud end for
each fitting.
▶ Make sure the right fittings, mounting bolts and threaded plugs are installed.
▶ For all female threads, use astud end from the same system ofunits and
ofthecorrect size.
Risk ofconfusion with
threaded connections

Bosch Rexroth A15VSO Specifications

General

Brand	Bosch
Model	Rexroth A15VSO
Category	Water Pump
Language	English