7.5 Symbols used
Table 6: Symbols used
21
Connection with T-bolt and fl ange nut.
Make sure the T-bolt is in the correct position when inserting it into the slot
and tightening it. The notch at the head of the screw indicates the orientation
of the T-bolt.
1 = T-bolt insertion position in the slot.
2 = T-bolt clamping position in the slot.
Tightening torque: 25 Nm
M
D
SW13
= 20Nm
Hex wrench
SW = wrench size … mm
M
D
= required tightening torque ... Nm
M
D
= 8Nm
SW5
Hex socket wrench
SW = wrench size … mm
M
D
= required tightening torque ... Nm
PH3
PZ2
Screwdrivers for cross-head screws
PZ … = Pozidriv screw driver, size …
PH … = Phillips screw driver, size …
gleitmo 585 K Anti-Seize
Lubricate/lubricate with specifi c grease lubricant:
• gleitmo 585 K: gleitmo 585 K, www.fuchs-lubritech.com
• Anti-Seize: Food Grade Anti-Seize/Loctite 8014, www.henkel.com
GHD V 68
Oil
Oil
Oil
Lubricate/lubricate with specifi c mineral oil:
• GHD: Structovis GHD, www.klueber.com
• V 68: Mineral oil with a viscosity of 68
Loctite 243 Loctite 601
Secure the screws with:
• Loctite 243: Medium strength (detachable), www.loctite.de
• Loctite 601: High-strength screw retention (non-detachable), www.loctite.de
The marked parts are not required for the described assembly.
Dispose of the parts or use them for other purposes.
213
Graphical depiction of the installation steps.
The numbers correspond to the sequence of installation steps, in accordance with
the instructions in the accompanying text.
AB CX
Graphical depiction of the designation of components.
The letters denote the components mentioned in the accompanying text.
Detail view from a different direction, for example, the back or the bottom side of
the product.
18/84 Assembly
Bosch Rexroth AG, MIT: BS 2/C-…, BS 2/R-…, 3 842 563 834/2022-08
To Next Page
Loading...
