Bosch Rexroth BS 2/R-300 - BS 2;C-H, BS 2;R-H, BS 2;R-V+ 1200: Installing the Belt Section between Two Sections

7.6.5 BS 2/C-H, BS 2/R-H, BS 2/R-V+ 1200:
Installing the belt section between two sections
Fig. 8:
SW10
M
D
= 8 Nm
M
4x
D
= 7 Nm
SW4
10
ST 2/C-H
ST 2/R-H
ST 2/R-V
ST 2/C-H
ST 2/R-H
ST 2/R-V
6
52
1
3
3
M
4x
D
= 7 Nm
SW4
4
3
25
563 833-05
M8x20
(4x)
M8x25
(4x)
M8
(4x)
M8
(12x)
4x
4x
4x
8x
4x
3 842 528 1923 842 518 828
M8x50
(4x)
M8x25
(4x)
SW13
M
D
= 25 Nm
SW13
M
D
= 25 Nm
BS 2/C-H, … : Installing the belt section between two sections
Required accessories:
• Connection kit
3 842 518 828 (0.5x)
• Connection kit
3 842 530 868 (0.5x)
Please note:
• Support the belt section
if necessary with section
supports (see page 19).
1. Remove the gear motor.
2. Remove the side
cover plates.
3. Install the connection kit
3 842 518 828 (2x).
4. Install the connection kit
3 842 530 868 (2x).
5. Mount the side
cover plates.
6. Mount the gear motor.
24/84 Assembly
Bosch Rexroth AG, MIT: BS 2/C-…, BS 2/R-…, 3 842 563 834/2022-08