Bosch Rexroth BS 2/R-300 - Changing glide profiles

Maintenance and repair 79/84
3 842 563 834/2022-08, MIT: BS 2/C-…, BS 2/R-…, Bosch Rexroth AG
10.4.27 Changing the glide profi les: BS 2/R-300, …-700, BS 2/R-H, BS 2/R-V+ 1200
Fig. 62:
563 833-76
.../R .../R-H .../R-V
5x
5x
!
2
A
1
)
2
)
B
.../R
C
X
.../R
Y
E
D
Changing the glide profi les: BS 2/R-300, …-700 (shown), BS 2/R-H, BS 2/R-V+ 1200 (1/2)
Required accessories:
• Assembly aid GP 2
(A, yellow) for inserting
the glide profi le into the
section profi le ST 2/R,
…/R-H
(set, 5 pieces)
3 842 564 982
• Assembly aid GP 2
(B, red) for inserting
the glide profi le into the
section profi le ST 2/R-V
(set, 5 pieces)
3 842 564 984
• Glide profi le (C)
– GP 2/H-ST
3
)
(48 x L=3000 mm)
3 842 564 315
– GP 2/H-KS
4
)
(24 x L=6000 mm)
3 842 564 314
• Guide profi le (D)
– FP 2/C/R
4
)
(12 x L=6000 mm)
3 842 567 261
• Glide profi le (E)
– GP 2
4
)
(24 x L=6000 mm)
3 842 567 260
1
) yellow
2
) red
3
) ST = steel
4
) KS = plastic
1. Remove the chain,
see chapter “Changing
the conveyor chain”.
2. Clean the interior (X)
of the section profi le
thoroughly.
Please note:
Before removing the glide
profi les, thoroughly clean
the interior (X) of the
section profi le of grease,
dirt and other impurities.
Dirt in the slots (Y) prevents
the assembly of the glide
profi les in the correct
position.
ENGLISH