Technical data 83/84
3 842 563 834/2022-08, MIT: BS 2/C-…, BS 2/R-…, Bosch Rexroth AG
16 Technical data
• For dimensions, see sales catalog TS 2plus.
• Maximum load/section load:
– BS 2/C-100 belt section: max. 100 kg / 1.0 kg/cm support surface length
– BS 2/C-250 belt section: max. 250 kg / 1.0 kg/cm support surface length
– BS 2/C-H belt section: max. 400 kg / 2.0 kg/cm support surface length
– BS 2/R-300 belt section: max. 300 kg / 1.5 kg/cm support surface length
– BS 2/R-700 belt section: max. 700 kg / 1.5 kg/cm support surface length
– BS 2/R-H belt section: max. 1200 kg / 2.0 kg/cm support surface length
– BS 2/R-V+ 1200 belt section: max. 1200 kg / 1.5 kg/cm support surface length
• Noise emissions: < 70 dB (A)
16.1 Ambient conditions
• The transfer systems have been designed for stationary use in a location
that is protected from the elements.
• Operating temperature +5 °C to +40 °C
–5 °C to +60 °C at 20 % reduced load
• Storage temperature –25 °C to +70 °C
• Relative humidity 5% to 85%
• Air pressure > 84 kPa, corresponds to an installation
altitude < 1400 m above sea level
• Max. load capacity of fl oor: 1000 kg/m
2
• At installation altitudes > 1400 m, the load values of the electric drives
are reduced by 15%.
• The area should be kept free of mold, fungus, rodents and other vermin.
• Do not install or operate in the immediate vicinity of industrial equipment
producing chemical emissions.
• Do not install or operate near sources of sand or dust.
• Do not install or operate in areas that are regularly subjected to
high-energy forces caused, for example, by presses or heavy machinery.
• Resistant to many media that are commonly found in manufacturing,
such as water, mineral oil, grease, and detergents. Contact your Rexroth
representative if you have any doubts about resistance to specifi c
chemicals, such as test oil, doped oils, corrosive detergents,
solvents or brake fl uid.
• Avoid prolonged contact with highly reactive acidic or alkaline materials.
ENGLISH
To Next Page
Loading...
