CAUTION
Hot electric motor surfaces during operation!
Risk of burns from touching hot surfaces above 65 °C
Install appropriate guards.
Let the unit cool down for at least 30 minutes before performing maintenance
and/or repair work.
• Only inspect and adjust continuous conveyors that are in motion or operation when
the protective equipment is in place.
• Observe DIN EN ISO 13857 when you remove or replace safety guards and/or
bypass protective equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.
Maintenance and repair 41/84
3 842 563 834/2022-08, MIT: BS 2/C-…, BS 2/R-…, Bosch Rexroth AG
ENGLISH
To Next Page
Loading...
