Bosch Rexroth ctrlX SAFETY SAFEX-C.12 - Connection of the Safe Digital Inputs and Outputs

ctrlX SAFETY | Installation, removal, replacement and electrical installation 29/83
DOK-XSAFE*-SAFEX-C.1XC-IT03-EN-P, Edition 03, Bosch Rexroth AG
The installation and removal are performed according to the procedure described below
depending on the wire end type.
Tabelle 14:
Wire end type Installation Removal
Solid contact wire 1. Place the wire end
on the contact point
2. Slide it in until the
stop!
1. Push in the release slider
next to the contact point
with a screwdriver
2. Pull the wire out of the
contact point
3. Pull back the screwdriver
Straight strand (untwisted)
1)
1. Push in the release
slider next to the
contact point with a
screwdriver
2. Place the wire end
on the contact point
3. Slide it in until the
stop!
4. Pull back the
screwdriver
Strand
1)
and wire ferrule 1. Place the wire end
on the contact point
2. Slide it in until the
stop!
Strand
1)
and wire ferrule with collar 1. Place the wire end
on the contact point
2. Slide it in until the
stop!
1) in all applications, “straight (untwisted)” applies to the version without wire ferrule
6.5.4 Connection of the safe digital inputs and outputs
You can find further information about the digital inpts and outputs in Installation manual
ctrlX SAFETY SAFEX-C.1* devices DOK-XSAFE*-SAFEX-C.1XC-COxx-DE-P.