Bosch Rexroth EcoDrive 03 - X6 Temperature Monitoring and Holding Brakes

5-8 Instructions for Use Rexroth EcoDrive 03 DKC**.3-016
DOK-ECODR3-DKC16*UL***-IB01-EN-P
Mains connections
The mains connector serves as the connection of the drive controller with
the power supply.
AP5399f1.FH7
L1
L2
L3
L1
N
n.c.
device-external device-internal
X5
Fig. 5-16: Single-phase mains connection
AP5400f1.FH7
X5
L1
L2
L3
L1
L2
L3
device-external device-internal
Fig. 5-17: Three-phase mains connection
Note: Mains connections should not be daisy-chained between the
units (intermediate connectors for the supply source should be
used).
XE2
X6, Motor temperature monitoring and holding brakes
Technical description of connector
Ap5382f1.FH7
123 456
Fig. 5-18: Connector X6
Type No. of pins Design
Spring contact 2 x 3 Bushing on connector
Fig. 5-19: Design
Cross section
single wire
[mm²]
Cross section
multi core wire
[mm²]
Wire size
in AWG
Gauge no.:
0.2-2.5 1.5-2.5 16-12
Fig. 5-20: Connection cross section
Single-phase mains connection:
Three-phase mains connection:
Protective conductor connection
Illustration:
Design:
Connection cross section: