5-14 Instructions for Use Rexroth EcoDrive 03 DKC**.3-016
DOK-ECODR3-DKC16*UL***-IB01-EN-P
min. tightening torque
[Nm]
max. tightening torque
[Nm]
2.5 3.0
Fig. 5-32: Tightening torque
Cross section
single wire
[mm²]
Max. connectable
cross section
in mm²
Max. wire size
in AWG
gauge no.:
-- 25 --
Fig. 5-33: Connection cross section
Allocation
Motor
Mains
XS1, XS2, XS3 Shield Connections
XS1
Connection for shield:
• Total motor cable shield
• Holding brake
• Motor temperature monitoring
XS2
Connection for shields of cables at X1 and those for the command
communication interfaces.
XS3
Connection for shields of cables at X3 and X10.
6 - 15 mm (for all shield connections)
Note: Always connect the shield connections of the cables
(especially of the motor cables) with a large contact surface.
H1, S1, S2, S3: Diagnostic display, Reset key, Address switch
Fig. 5-34: H1: Diagnostic display, S1: Reset key, S2, S3: Address switch
H1
Number of diagnostic messages (errors and operating states).
Tightening torque:
Connection cross section:
XE1
XE2
Allowed outside diameter:
To Next Page
Loading...
