6/70 About this documentation
Bosch Rexroth AG, General Operating Instructions HYDROTRAC GFT 8000 series 40, RE 79022-01-B/04.2020
1.3 Presentation of information
So that you can work with this documentation fast and with certainty when using
your planetary gearbox, uniform safety instructions, icons, terminology and
abbreviations are being used. For better understanding, these are explained in the
following sections.
1.3.1 Safety instructions
In this documentation, safety notes are located in chapter 2.6 “Product and
technology-dependent safety instructions” and in chapter 3 “General information
concerning damage to property and product damages”, as well as before any
sequence of actions, or sequence of instructions, where there is a danger of
damage to persons or property. The measures described for avoiding hazards must
be observed.
The safety instructions are structured as follows:
• Warning symbol: draws attention to the danger
• Signal word: identifies the degree of the danger
• Type and source of danger: identifies the type and source of danger
• Consequences: describes what occurs if the safety instructions are not complied
with
• Precautions: states how the danger can be avoided.
Table 2: Danger categories according to ANSI Z535.6
Warning symbol, signal word
DANGER
identifies a dangerous situation where death or
serious personal injury will result if it is not avoided
WARNING
identifies a dangerous situation where death or
serious personal injury may result if it is not avoided
CAUTION
identifies a dangerous situation where mild to medium
personal injury will result if it is not avoided
identifies damage to property: The product or the
environment can get damaged.
Type and source of danger
Consequences in the case of non-compliance
Measures for danger aversion
<List>
To Next Page
Loading...
