R911299720 / 02 | Rexroth IndraControl VCP 25 Electric Drives and Controls | Bosch Rexroth AG 6-3
Display and Operating Components
6.2 Touch Screen
The device is equipped with a resistive 4-wire touch screen. You oper-
ate the small operator terminal using this touch screen.
6.3 Reset Key
The reset key is located on the rear of the device. You can use this key
to restart the device.
6.4 User Mode Switch
The user mode switch is located on the rear of the small operator termi-
nal.
Legend for table:
I = Switch ON
- = Switch OFF
X = Any switch position
The switch positions for ON or OFF are printed onto the user mode
switch.
S1 S2 S3 S4 Operating Mode
I X – – Standard mode with PLC (default upon delivery)
I X I – Standard mode without PLC
I – – I Activate download (erases the application mem-
ory) and default contrast / brightness setting
I – I I Activate upload
– – – – Calibration mask is called-up during start-up
– – I – Calibration mask is called-up during start-up and
the calibration process is started immediately
Fig. 6-2: User mode switch
To Next Page
Loading...
