Bosch Rexroth IndraControl VCP 25 - Cable; Diagnostics; Fig. 7-26: Arrangement of the INTERBUS Diagnostics Leds; Fig. 7-27: Functions of the INTERBUS Diagnostics Leds

R911299720 / 02 | Rexroth IndraControl VCP 25 Electric Drives and Controls | Bosch Rexroth AG 7-17
Interfaces
7.2.2.2 Cable
7.2.2.3 Diagnostics
The diagnostics LEDs are located at the rear of the small operator ter-
minal. The LEDs show the states of the bus system.
Fig. 7-26: Arrangement of the INTERBUS diagnostics LEDs
The diagnostics LEDs at the small operator terminal has the following
functions:
A shielded twisted-pair cable (cable type LiYCY-TP) must be used. The
maximum cable length depends on its use within the INTERBUS topol-
ogy.
Designation Color State Function
RC Green On Remote Bus Check
+5 V Green On Supply Voltage OK
Off No Supply Voltage
BA Green On Bus Active
Off Bus Not Active
RD Red On Remote Bus Inactive
Fig. 7-27: Functions of the INTERBUS diagnostics LEDs