Bosch Rexroth IndraControl VCP 25 - Ejecting the Memory Card; Shielding D-SUB Connectors; Fig. 7-36: Ejecting the Memory Card; Fig. 7-37: Shielding D-SUB Connectors

R911299720 / 02 | Rexroth IndraControl VCP 25 Electric Drives and Controls | Bosch Rexroth AG 7-23
Interfaces
7.3.2 Ejecting the Memory Card
To remove the card, press the ejection button on the operating device.
Fig. 7-36: Ejecting the memory card
7.4 Shielding D-SUB Connectors
You must shield D-SUB connectors as follows:
Fig. 7-37: Shielding D-SUB connectors
1 D-SUB connector
2 Shield
3 Cable clip
4 Cable
The shield must be folded back into a flat position over the cable
sheath.
When fastening the cable with the cable clip, as much of the shielding
as possible must be in contact with the housing and sufficient strain
relieve must be ensured.