Combined encoder for SSI (5 V supply voltage)
The
combined encoder for SSI is a combination of SSI and sin-cos encoder
1V
pp
.
See the connection diagram for how to connect the encoder system.
Connection diagram
1) Line cross section ≥ 0.5 mm²; observe allowed encoder cable
length
2) Line cross section ≥ 0.14 mm²
Fig. 8-11: EC connection diagram with SSI encoder system
Power supply
5 V (the voltage is made available via the EC interface)
Technical specification of the power supply: See chapter "5 V power supply"
on page 92
Cable Length
75 m at most (when using the Sense function)
When you do not use the Sense function, the maximum cable length is re‐
duced (see chapter 8.1.4 "Encoder cable length" on page 94).
Technical properties
Use the Sense function to ensure stable power supply at the encoder. De‐
scription of the Sense function: See chapter "5 V power supply" on page 92
DOK-INDRV*-CXX02******-PR03-EN-P Bosch Rexroth AG 89/143
IndraDrive Control Sections CSB02, CSE02, CSH02, CDB02
Technical data - functions
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
