194/263 Bosch Rexroth AG | Tightening Technology 3 608 870 A47
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-
Tightening
Timeout options
9.6.3.4 End step
A job ends with the end step.
General
Options
Table 9–30: Single program dialog - tightening panel
Element Description
Tool display text You can save a text for all steps. The text will be displayed on the tool display.
Enable tool Enable nutrunner is activated (display only): The nutrunner is enabled in this
step.
Tightening program – Program no.
Defines the tightening program that is to be processed next in this stop
step. Integer values between 0 and 255 (tightening programs 0-255) are
valid characters.
–Max. OK
Defines the maximum number of OK tightening operations for this tighten-
ing program. Integer values between 0 and 255 are valid characters.
–Max. NOK
Defines the maximum number of NOK tightening operations for this tight-
ening program. Integer values between 0 and 255 are valid characters.
Conditional blocking of the loosen
program
– Block loosen program after OK tightening
Blocks the loosen program no. 99 after an OK tightening.
– Block loosen program after NOK tightening
Blocks the loosen program no. 99 after a NOK tightening.
Table 9–31: Single program dialog - timeout options panel
Element Description
Timeout Enter the maximum time when an event has to take place. If no event occurs
in this time, the step is terminated.
Error message Enter an error message that will be displayed on the tool display after the tim-
eout.
Double clicking the end step or the respective icon opens the corresponding dialog for en-
tering the parameters.
Table 9–32: End step dialog – General panel
Element Description
Name End step name
Admissible characters are ASCII characters, numbers, spaces, hyphens,
dashes and underscore.
Comments Description of the job step
Admissible characters are ASCII characters, numbers, spaces, hyphens,
dashes and underscore.
Table 9–33: End step dialog – options panel
Element Description
Enable nutrunner Enable nutrunner is disabled (display only): The nutrunner is disabled in this
step.
To Next Page
Loading...
