42/263 Bosch Rexroth AG | Tightening Technology 3 608 870 A47
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-
Table 3–2: Entries for the main menu
Element Description Screen
Actual values Screen displaying the current tightening results:
– Torque (T)
–Angle (A)
–Time (t)
– Identification code (ID)
The display is based on the tightening result - OK or NOK. For NOK
tightening, the screen is flashing with the parameter causing the NOK
result highlighted in red.
Operating mode As of Nexo firmware version 1300. Change-over between manual
mode and automatic mode.
Program selection A selection of configured tightening programs available for selection
if the Prog0 … Prog7 PLC signals are fully applied on the tool PLC
module.
Job selection As of Nexo firmware version 1300. A selection of configured jobs
available for selection if the Job0 - Job7 PLC signals are fully applied
on the tool PLC module.
Language selection Selection of the display language:
Chinese, German, English, Spanish, French, Italian, Hungarian, Pol-
ish, Portuguese, Slovak, Czech, Russian
System information Screen displaying hardware and software version of the Nexo cord-
less Wi-Fi nutrunner as well as additional information like IP address
and WLAN network.
Time & date System time settings (date and time).
Design Selection of day or night design for the screen display.
ID code display Display of the current ID code.
Job On the tool display, the active job can be canceled.
To Next Page
Loading...
