3 608 870 A47 Tightening Technology | Bosch Rexroth AG 53/263
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-05
3.3.3.1 Control via VW-XML master PC
The VW-XML master PC controls the Nexo cordless Wi-Fi nutrunners and receives the tightening results.
For this purpose, a VW-XML master software has to be available at the IPC. The data may be transmitted
via WLAN to a VW-XML master PC or via one or several external access points (see figure 3–9).
Settings in the NEXO-OS operating system:
• To configure the WLAN connection, go to Settings WLAN (page 230).
• To set the communication with VW-XML, go to Settings Data VW-XML (page 221).
• The PLC assignment table has to be applied as specified in chapter VW-XML protocol. To set the
PLC assignment table, go to Settings PLC signals (page 226).
•
The tag <PI1> defined in the VW-XML protocol can be
applied as ID code in Nexo. For this purpose, the Selection of ID code source can be set to VW-XML under mode in the start step (see
page 185).
Fig. 3–9: Control via VW-XML master PC
As of Nexo firmware version 1200, the VW-XML protocol is supported. VW-XML version 2.1 is supported.
Application of the VW-XML protocol outside of VOLKSWAGEN AG is subject to express written agree-
ment of VOLKSWAGEN AG.
(1) IPC (industrial PC) with VW-XML master software
(2) Access point
To Next Page
Loading...
