614–30.0212.0270–01 A2 10
Explanation of Display and Operating Elements
Cursor keys / key switch / sealed switch
Move to the next position by
pressing the appropriate key
up/down
left/right
Cursor keys
The requested position of
the cursor within the display
can be selected using the
appropriate cursor keys
(e.g. when selecting
detectors, detector zones or
functions).
Additional information is
displayed.
123456
78 9101112
Storage room entrance 1st floor
1
0
2
Key switch
The assigning of operating functions to the position of the key switch can be programmed,
e.g. – internal program on/off
– code operation on/off
Sealed switch
“General Reset”
If the operator cannot reset the system (e.g. after a sabotage alarm), resetting can be per–
formed without entering an operator code by actuating the sealed switch. This should only
be done after prior consultation with the Service Department. (“General Reset” is only pos-
sible if programmed).
To Next Page
Loading...
