614–30.0212.0270–01 A2 15
Calling up
reset
Enter operating code (see section
Operating Authorisation) and se-
lect zone/message type to be
reset: (see page 12).
Message Display / Processing
Resetting detector zones / message types
Resetting
single zones
Resetting single
message types
The softkey “MESS.TYPE”
resets all triggered detectors of
all detector zones of the selec-
ted message type (e.g. IN-
TRUSION internal).
When all reset detectors are in
stand–by mode, the type of
message is no longer shown in
the display.
If the zone cannot be reset by the authorised personnel,
contact the Service Department.
The softkey “SINGLE” resets
all triggered detectors of the
detector zone (e.g. 0035) of
the selected message type.
When all reset detectors are in
stand–by mode, the message
is no longer shown in the dis-
play.
reset
TOTAL MESS.TYPE SINGLE
TOTAL MESS.TYPE SINGLE
If the type of message cannot be reset by the authorised
personnel, contact the Service Department.
1 INTRUS. INT ZONE 0035 – 16
Storage room Entrance 1st floor
RESET MESS.TYPE: INTRUSION
1 INTRUS. INT ZONE 0035 – 16
Storage room Entrance 1st floor
RESET MESS.TYPE: INTRUSION
To Next Page
Loading...
