614–30.0212.0270–01 A2 12
Key “MESS.TYPE”:
Using the key “MESS.TYPE”,
additional triggered message
types are scrolled. If several
message types are present,
they are displayed according
to their priority.
Key “DETECTOR”:
Detector No. 16 from detector zone 0035 reports an inter-
nal intrusion. Using the key “DETECTOR”, all triggered
detectors of this detector zone are displayed.
Using the cursor keys, all triggered detectors of this detec-
tor zone can then be selected within the display.
Using the same key (the key becomes an information key)
the display shown above is reset for the selected detectors.
Message: When messages appear, the alarm organisation has to be respected.
Key “ACTIONS”:
Using the key “ACTIONS”, a
text for additional measures
can be called up (e.g., infor-
ming custodian, Tel. 3434).
After the key is pressed again,
the previous display appears
again.
1 INTRUS. INT ZONE 0035 – 16
Storage room entrance 1st floor
3 INTRUS. INT ZONE 0040 – 07
Office building south 1st floor
MESSAGES DETECTOR MESS.TYPE ACTIONS
Key “MESSAGES”:
A total of 3 detectors (detector
zones) of the message type
(e.g. “Intrusion internal”) are
present. The display indicates
the first message to arrive (1)
with detector zone No. 0035
and detector No. 16 and the
last message to arrive (3) with
detector zone No. 0040 and
detector No. 07.
Using the key “MESSAGES”,
the following messages (de-
tector zones) of the selected
message type scroll into the
first line of the display.
Ca. 30 seconds after a key has been pressed, the first and the last
message with the highest priority reappear in the display.
Message Display / Processing
Messages with message processing keys
To Next Page
Loading...
