614–30.0212.0270–01 A2 16
Resetting all existing
messages using
“General Reset”
If the authorised personnel cannot reset the system (e.g. after a sabotage alarm),
resetting is possible without operator code after consultation with the Service
Department.
Resetting is performed as follows:
Break the seal covering the “General Reset” switch. Then actuate switch by inserting
a pointed object.
The central control unit is reset and the messages in the displays are deleted as soon
as the detectors enter the stand–by mode or the malfunctions are eliminated.
The seal must later be replaced by the Service Department.
Message Display / Processing
Resetting with “General Reset”
To Next Page
Loading...
