614–30.0212.0270–01 A2 14
Message Display / Processing
Resetting the central control unit
Calling up
reset
Resetting the
central control unit
reset
Enter operating code
(see section
Operating Authorisation)
TOTAL MESS.TYPE SINGLE
TOTAL MESS.TYPE SINGLE
The softkey “TOTAL” resets all
detectors triggered by the
central control unit.
The quiescent condition
picture appears in the display
as soon as the central control
unit is in quiescent condition.
If certain triggered detectors
cannot be reset by the author–
ised personnel, inform the Ser-
vice Department.
1 INTRUS. INT ZONE 0035 – 16
Storage room Entrance 1st floor
RESET MESS.TYPE: INTRUSION
1 INTRUS. INT ZONE 0035 – 16
Storage room Entrance 1st floor
RESET MESS.TYPE: INTRUSION
To Next Page
Loading...
