614–30.0212.0270–01 A2 22
Maintenance:
with hood removed, press “Code” (technician)
Complete operation: code for operation authorisation 2
Basic operation: code for operation authorisation 1
Operation without operator code
Maintenance:
with hood removed, press “Code” (technician)
Complete operation: code for operation authorisation 2
Basic operation: code for operation authorisation 1
Operation without operator code
x = Operation can be carried out with appropriate code.
x = Operation can be carried out with appropriate code only if programmed.
Operable functions 0 1 2 3 Operable functions 0 1 2 3
Switch on/off (page 38 ff.)
– Group list/zones (x) (x) x
– Detectors (x) (x) x
– Tableau points xx
– Sounders/strobes xx
– View switchoffs xxxx
Maintenance (page 43)
– Zones xx
– Detectors xx
– Sounders/strobes xx
– Check SD key safe x
– Detector test xxxx
Maintenance (page 43)
– Change LSN modular processing LVM
(in case of redundancy) x
– View status of maintenance xxxx
Block (page 44 ff.)
– Block zones x
– Block detectors x
– View blockings xxxx
continued on next page
Operation Authorisation
Basic/complete/maintenance operation
To Next Page
Loading...
