Bosch Worcester Greenstar CDi Conventional Series - Finishing Commissioning

,A
:---------------1
I I
/ I
I
~ORCESTER INSTALLATION & SERVICING INSTRUCTIONS FOR WORCESTER BOSCH GREENSTAR 30CD,/40CD' Conven\1onal
Bosch Group
6 720 614 556a (2007/07)
FINISHING COMMISSIONING
The boiler has been factory set, so there
should be no need to adjust combustion
settings.
REPLACE OUTER CASING:
Replace
outer casing making sure that the
securing points are
properly located.
~ Press the clip (A) downwards to secure
casing
on top.
~ Retighten bottom two screws (B).
INSTALLING BOTTOM PANEL:
2 The bottom panel slides onto two ledges
(C)
either side of the boiler frame.
~ Hold the panel up against the underside
of the
boiler and slide towards the rear until
it is fully engaged.
HAN
DOVER:
~ Complete the Benchmark check list.
~ Open the facia cover by gently pressing the
centre top of the cover
(D).
~ Set up the controls and show the user how
to operate
all the controls shown in the User
Guide.
~ Place the user guide into the tray (E) on the
inside of the facia cover.
~ If the appliance is unused and exposed to
freezing conditions; shut off
all the mains
supplies and drain the system and boiler .
.,.,.- ... ------ .................
/~"" .... ,,
'\
\
\
------ ~ \
D
E
/
/
FINISHING COMMISSIONING
I
I
I
I
I
I
I
I
I