SYSTEM CONTROLS AND INDICATORS
Remote control
Remote
status
LED
® @ @
@ @
o ® o
Pa_e J
• Turns the system on or off.
@
Status LED:
* Remains off (unlit) during normal operation.
* Remains on during setup mode. Turns off briefly with each key press.
* Blinks rapidly eight times if the wrong key is pressed during setup or if an
unavailable device code is entered.
* After ten seconds of no key presses, blinks rapidly eight times and the remote
exits the setup mode.
* Silences or restores the sound from the current source.
* Selects the built-in CD/DVD player and turns the system on.
* Selects the built-in tuner and turns the system on to the previously selected FM/
AM station.
* Switches between FM and AM when the tuner is selected.
®®
• TV: Turns your system on and selects the TV input as the sound source.
• Input: Changes the external input to your TV. For example, your TV
might have two external inputs where one is connected to your cable
box and the other to your VCR. Pressing this button alternates between
the cable box and the VCR.*
• On/Off: Turns your TV on and off.*
©
• CBL.SAT: Turns your system on and selects the CBL.SAT input as the sound
source.
• On/Off: Turns your cable/satellite box on or off.*
II
@
• AUX: Turns your system on and selects the AUX input as the sound source.
• On/Off: Turns a VCR or DVR that is connected to the AUX jack on or off.*
* Requires special remote settings. See "Setting up your remote to control other audio/video devices"
on page 30.
26
To Next Page
Loading...
Need help?
General
