Bose CineMateSERIES II - Troubleshooting Common Issues

33
CARE AND MAINTENANCE
TAB 5TAB 4TAB 6TAB 8TAB 7English TAB 3TAB 2
Troubleshooting
Problem What to do
No power • Unplug the Acoustimass
®
module power cord from the AC wall outlet for one minute.
• Make sure the power cord is inserted securely into the Acoustimass module.
• Reconnect the power cord firmly into an operating AC wall outlet. The green LED should flash 10 times,
then extinguish (the system will then be in standby).
• Make sure the interface module is plugged into the Acoustimass module properly.
• Make sure you use the remote control to power on the system.
No sound • Make sure the CineMate
®
system turned on. The green LED on the front of the interface module should be
lit when the system is on.
• Increase the volume.
• If your system is a CineMate GS series II, make sure you pressed the remote button for the source you want
to hear.
• Make sure the interface module and speaker cables are both firmly connected to the Acoustimass module.
• Check the connections on the back of the speakers.
• If using a source device other than the TV, make sure the device is turned on and is playing.
00.Kaiser_OG.book Page 33 Friday, June 24, 2011 2:48 PM