Bose L1 II

4
Specifications
External Dimensions
Cylindrical Radiator
®
: Height: 2070 mm Width: 89 mm Depth: 120 mm
Power Stand: Height: 110 mm Width: 200 mm Depth: 660 mm
(Legs Folded)
Bass Module: Height: 380 mm Width: 260 mm Depth: 450 mm ± 10 mm
Weight
Cylindrical Radiator: 15 lbs (6.8 kg) each section.
Power Stand: 20 lbs (9.1 kg)
Bass Module: 27 lbs (12.3 kg)
Input / Output Panel Connections
Line-level Inputs: (1) Input (1/4in” TRS)
Line-level Outputs: (1) Bass Out (1/4in” TRS)
Speaker Outputs: (1) Bass Out (Neutrik NL4)
Data In & Power: (2) Ethercon / RJ45
Power Input: (1) IEC Connector - recessed
Input / Output Panel Controls:
Input Trim (1)
Display (1) LED for Preamp signal present/clipping
(1) LED of Power On and Fault Condition Display
Electrical Specifications:
Note: All measurements made in “Debug” mode [ No EQ or Limiting]
Balanced ¼” Line Input to Bass Line Output assuming 10dB of digital gain
Description System State Specification
Input Impedance (Unbalanced) 10 kOhm +/- 10%
Maximum Input Voltage Trim @ Min, <1% THD 20 V Min
THD @ Rated Power Trim @ Max, Vin = -
20dBV
0.1% Max 30Hz to 15kHz
S/N Ratio (Dynamic Range), A-wtd Trim @ Max, Ref. 1%
THD
80 dB Min.
Frequency Response Trim @ Max, Vin = -
30dBV
20Hz to 20kHz +/- 1dB
Line Input Gain – Trim Control @ Max. Vin = 32mV (-30dBV) +30dB (0dBV)+/-2dB
Line Input Gain – Trim Control @ 12.00 Vin = 32mV (-30dBV) +10dB (-20dBV) +/-3dB
Line Input Gain – Trim Control @ Min. Vin = 32mV (-30dBV) < -80 dBV
Line Input – Line Output Polarity Non-Inverting