Boss GT-PRO - Customizing the Speakers

58
Chapter 5 Creating Original Effects Types (Customize)
Customizing the Speakers
You can make two different sets of settings, Custom 1 and
Custom 2.
* The sound of any patch that uses Custom 1 or 2 will be altered
if the custom settings are edited.
fig.05-0100
1. Press the PREAMP/SPEAKER [SPEAKER].
2. Rotate the PATCH/VALUE dial to call up “Custom 1”
or “Custom 2.”
fig.05-0110d
3. Press PARAMETER [ ] [ ] to show the custom
parameters.
4. Rotate the PATCH/VALUE dial to change the setting’s
value.
5. Repeat Steps 3 and 4 as needed.
6. Press [EXIT] to return to the Play screen.
Preamp High
fig.05-0090d
-50–+50
Adjusts the preamp section’s high-frequen-
cy tone.
Parameter/
Range
Explanation
2,4 3
6
1
Parameter/
Range
Explanation
Speaker Size
fig.05-0120d
5”–15” Selects the size of speaker.
Color Low
fig.05-0130d
-10–+10
Adjusts the speaker section’s low-frequency
tone.
Color High
fig.05-0140d
-10–+10
Adjusts the speaker section’s high-frequen-
cy tone.
Speaker Num (Speaker Number)
fig.05-0150d
x1, x2, x4, x8 Sets the number of speakers.
Cabinet
fig.05-0160d
Open, Close Selects the speaker cabinet type.
Open
This is an open-backed cabinet.
Close
This type of cabinet features an enclosed rear panel.