Boss Modulation MD-200 - Menu Parameter List

Overall Settings (Menu)
12
Menu Parameter List
About the
MEMORYMEMORY
mark
5 Can be set and saved for each memory by the “Saving to Memory” (p.
10) operation. If you do not perform this operation, the settings are lost
when you switch memories.
5 Can be set and saved for each memory if the preference (SWP/MEP/C1P/
C2P/EPP) is set to MEM (MEMORY). To save, refer to “Saving to Memory”
(p. 10).
If set to SYS (SYSTEM), the settings common to the unit are used. Function
settings are saved automatically.
Parameter Explanation
tHd
(TEMPO HOLD)
oFF: Operates using the tempo/rate of
the memory.
on: Operates using the tempo/rate of the
previous memory.
Parameter Explanation
SWF
(ON/OFF SWITCH
FUNCTION)
Specify the functions of the [ON/OFF]
switch, [MEMORY/TAP] switch, and
footswitches connected to the CTL 1, 2/
EXP jack.
* The functions that can be assigned dier
depending on the switch.
oFF: No operation.
SW
(ON/OFF SWITCH) : Turns the eect on/o.
MoM
(MOMENT) : The eect is on only while
you hold down the switch.
MAn
(MANUAL) : Selects manual.
M-1
(MEMORY 1) : Selects memory 1.
M-2
(MEMORY 2) : Selects memory 2
M-3
(MEMORY 3) : Selects memory 3.
M-4
(MEMORY 4) : Selects memory 4.
MUP
(MEMORY UP) : Increments the memory
number according to the MEMORY
EXTENT setting.
Mdn
(MEMORY DOWN) : Decrements the
memory number according to the
MEMORY EXTENT setting.
tAP
(TAP TEMPO) : Operates as tap tempo.
MFC
(MEMORY SWITCH
FUNCTION)
C1F
(CTL1 FUNCTION)
C2F
(CTL2 FUNCTION)
MEMORYMEMORY
MEMORYMEMORY
MEMORYMEMORY
MEMORYMEMORY
MEMORYMEMORY