Boss Modulation MD-200 - Page 15

Overall Settings (Menu)
15
Parameter Explanation
Pot (PC OUT)
Species whether program changes
are transmitted (on) or not transmitted
(oFF).
Correspondence between memories
and program numbers
Memory Program number
MAN
1
MEMORY 1–4
2–5
CCI (CC IN)
Species whether control changes are
received (on) or not received (oFF).
By receiving CC messages, this unit
lets you use MIDI to control the same
operations as a knob or footswitch.
CCO (CC OUT)
Species whether control changes are
transmitted (on) or not transmitted
(oFF).
Parameter Explanation
RTC (RATE CC)
Specify the controller number
corresponding to each controller.
oFF, 1–31, 64–95
DPC (DEPTH CC)
ELC (E.LEVEL CC)
P1C (PARAM1 CC)
P2C (PARAM2 CC)
P3C (PARAM3 CC)
SWC
(ON/OFF SWITCH CC)
MEC (MEMORY CC)
C1C (CTL1 CC)
C2C (CTL2 CC)
EPC (EXPRESSION CC)
EFC
(EFFECT ON/OFF CC)
SYN (SYNC)
Species the tempo clock to which this
unit will synchronize.
int
(INTERNAL): Synchronize to the internal
tempo.
Aut
(AUTO): Normally synchronize to
the internal tempo, but if MIDI clock is
being input via the MIDI IN connector,
synchronize the tempo to MIDI clock. If
you’re using the MD-200 as a slave device,
choose the “Aut” setting.