Boss Modulation MD-200 - Page 4

Panel Descriptions
4
Mode PARAM 1 PARAM 2 PARAM 3
FLANGER (FLG)
RES
(RESONANCE)
Adjusts the amount of resonance
(feedback).
MAN (MANUAL)
Adjusts the center frequency at
which the eect is applied.
LOC (LOW CUT FREQUENCY)
Cuts the frequency components
below the specied frequency.
With the FLT (at) setting, the low
cut lter is not applied.
PHASER (PHS)
RES
(RESONANCE)
Adjusts the amount of resonance
(feedback).
MAN (MANUAL)
Adjusts the center frequency at
which the eect is applied.
LOC (LOW CUT FREQUENCY)
Cuts the frequency components
below the specied frequency.
With the FLT (at) setting, the low
cut lter is not applied.
VINTAGE PHASER
(VPH)
TYP
(TYPE)
THR (THRU): Only phaser sound.
CRH
(CRUNCH): Distortion is added.
DRV (DRIVE)
Adjusts the amount of distortion
when CRH (CRUNCH) is selected.
TON (TONE)
Adjusts the tonal character when
CRH (CRUNCH) is selected.
CLASSIC VIBE (CVB)
TYP
(TYPE)
THR (THRU): Only phaser sound.
FUZ
(FUZZ): Distortion is added.
DRV (DRIVE)
Adjusts the amount of distortion
when FUZ (FUZZ) is selected.
TON (TONE)
Adjusts the tonal character when
FUZ (FUZZ) is selected.
VIBRATO (VIB)
TON
(TONE)
Higher values produce more
complex modulation.
D/E (DIRECT/EFFECT BALANCE)
Adjusts the volume of the direct
sound and the eect sound.
TON (TONE)
Adjusts the tonal character.