Boss Modulation MD-200 - Page 5

Panel Descriptions
5
Mode PARAM 1 PARAM 2 PARAM 3
TREMOLO (TRM)
TYP
(TYPE)
TRM (TREMOLO): Cyclically modulates
the volume.
PAN
(PAN): By alternately changing
the volume of left and right, this
produces the impression that the
sound is moving between the left
and right speakers when heard in
stereo. (If you don't use stereo output, this will
not produce the intended eect.)
WAV (WAVEFORM)
Selects the type of wave.
TON (TONE)
Adjusts the tonal character.
ROTARY (ROT)
SLW
(SLOW SPEED)
Adjusts the SLW (slow) rotation
speed.
FST (FAST SPEED)
Adjusts the FST (fast) rotation
speed.
R/H (ROTOR / HORN BALANCE)
Adjusts the balance between the
horn and the rotor.
AUTO WAH (AWH)
RES
(RESONANCE)
Adjusts the depth of the wah
eect in the region of the center
frequency.
FRQ (FREQUENCY)
Species the center frequency of
the wah eect.
TYP (FILTER TYPE)
LPF: Low-pass lter. Only the low-
frequency region is passed.
HPF: High-pass lter. Only the
high-frequency region is passed.
BPF: Band-pass lter. Only a
specic frequency region is passed.
SLICER (SLI)
PTN
(PATTERN)
Selects the pattern at which the
sound is sliced.
ATK (ATTACK)
Adjusts the attack volume of the
slice pattern.
DTY (DUTY)
Adjusts the length of sound for the
slice pattern.
OVERTONE (OVT)
LWR
(LOWER LEVEL)
Adjusts the overtone one octave
below.
UNI (UNISON LEVEL)
Adjusts the volume at which sound
that is slightly pitch-shifted is added
to the direct sound.
UPR (UPPER LEVEL)
Adjusts the overtone one octave
above.