Bowflex TreadClimber TC5000 - Step 19: Calibration Process (TC3000;TC5000)

Assembly Guide
Step 19: CALIBRATION PROCESS (TC3000 and TC5000 only)
Failureto calibrateyour machinepriorto use could result in machinefailure
and could cause injury.
During the entire calibration process, stand on the side foot support platforms or rubber
mat only, do notstand on the walking belts!
DO NOT STEP ON THE BELTS DURING
THIS ENTIRE PROCESS.
Owners of the TC3000 or TC5000 will need to ..............
calibrate the TreadClimber _ machine before they ._
can begin exercising. Owners of the TC1000 do not
need to complete this step.
Figure 19-1
Calibrating the TC3000 and TC5000 is an important Main Power Switch "On"
part of troubleshooting maintenance.
NO TE: YOUwill also need to re-calibrate
\ your machine in the event of
\ a power outage or if you have
replaced a TreadClimber _
component, such as a belt, or
motor.
19-1 Plug power cord into wall outlet.
19-2 Turn on Main Power Switch (see Figure 19-1).
19-3 Stand on the side foot support platforms or
rubber floor mat, DO NOT STAND ON THE
BELTS.
19-4 Insert the Safety Key, press and hold down the
POWER button, then very quickly press and
hold down the SLOWER button. Continue to
hold down the POWER and SLOWER buttons
(see Figure 19-2 for the TC5000 and Figure
19-3 for the TC3000).
AIOTE: If the Safety Key is not fully
inserted into the safety keyhole, the
TreadClimber _ machine will NOT
power up.
19-5 At this point you should see the numbers start
to decrease on the console.
Figure
TC5000 Power & Slower Buttons
J_
BOI/VFLEX
TreadClimbe_ TC3000
19-6 While continuing to hold down the POWER
and SLOWER buttons, remove and re-insert
the Safety Key. TC3000 Power & Slower Buttons
®
Bowfiex' TreadClimbe¢ _ Owner's Manual 24