Workout Instructions
6. Press FASTER to start the belts. Starting belt speed is 0.7 MPH (1.1 KPH).
NOTE: Belts may take two to three seconds to start.
7. Once the belts have started, you may step onto the treadles at any time.
NOTE: If you are new to the Bowflex _ TreadClimber _ machine, make sure to start your
workout at a slower speed, gradually increasing belt speed as your endurance
and fitness levels increase.
8. Press FASTER or SLOWER to increase or decrease belt speed as needed.
Starting a TreadClimber _ Workout (TCl000)
Do notstandon the treadleswhile startingor stopping
the walkingbelts-- to do so could cause injury.
1. Push START/STOP to start the walking belts--TIME starts counting as soon as you start the
belts.
.
3.
NOTE: The console will NOT power up if the Safety Key is not properly inserted into the
Safety Keyhole.
Once the belts have started, you may step onto the treadles at any time.
Press FASTER to increase your speed. Starting belt speed is 0.5 MPH (0.8 KPH).
NOTE: If you are new to the TreadClimber _ machine, make sure to start your workout
at a slower speed, gradually increasing belt speed as your endurance and
fitness levels increase.
4. Press FASTER or SLOWER to increase or decrease belt speed as needed.
®
Bowflex' TreadClimbe¢ _ Owner's Manual 48
To Next Page
Loading...
